Roof Truss Anchor Point

Truss boss kit 00420 truss boss anchor 00432.

Roof truss anchor point.

A spreader braces the trusses and distributes arrest forces across several trusses. Doesn t bend under normal working load. Anchor points are usually installed on the roof and are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling. Permanent adjustable standing seam roof anchor 53221 standing seam roof clamp 00250 2 way.

By permanently attaching a d ring anchor to the bottom chords of an overhead truss system we can create an osha compliant anchor point that serves as part of a fall arrest system. The embedded truss anchor series provides an engineered method to properly attach roof trusses to concrete and masonry walls. The snappy roof anchor meets all applicable standards for fall arrest. Can be installed in under 1 minute.

They can be reused according to the manufacturer s instructions. Unlike our connect safe portable truss anchors the fixed truss single point anchor is mechanically attached with steel plates and a threaded bolt and nut combination. Doesn t rely on penetration of timber member. Truss t grip is a fall arrest rope access roof anchor point with a unique clamping mechanism designed for use on rafters and trusses.

Unlike our connect safe portable truss anchors the fixed truss single point anchor is mechanically attached with steel plates and a threaded bolt and nut combination. Spreaders can act as anchors for personal fall arrest systems and fall restraint. Shock absorption through plastic deformation at loads over 6 kn. The products are designed with staggered nail patterns for greater uplift resistance.

These roof anchors are easy to install by nailing into the truss and easy to remove by hammering over the attachment point when the job is done. Into a poured concrete bond beam or grouted block wall staggered nail pattern for enhanced uplift resistance. We also have a range of self installation anchor point products available such as the rafter and truss kit which is our most popular self in uniplate anchor uni 01 the uniplate anchor has been designed to fit most metal roof profiles. It is important to refer to the truss manufacturer s instructions and have a qualified person determine if trusses will meet strength requirements for a personal fall arrest system or fall restraint system.

Truss anchorage locations must be approved by a safety engineer or a qualified person and must meet all of the requirements noted in the connect safe fixed truss anchor instruction manual. The uniplate can be fitted with either a fixed eyelet or an energy absorbing swivel eyelet. Roof anchors can be as simple as a d ring connection or as complex as a complete lifeline system.