Roof Truss Anchor

They provide an anchor point for fall arrest systems on roofs for maintenance work repair and new construction.

Roof truss anchor.

Bare wood truss anchors these fall protection anchors are designed to attached directly to a wood truss. The fixed truss anchor fall protection kit is a fast installing fall arrest solution that uses the structural truss design of your building to create an osha compliant tie off point for personnel working at heights. The snappy roof anchor meets all applicable standards for fall arrest. There are permanent and reusable options available.

It is strongly recommended that for trussed after roofs the truss clip is used whether or not it is specified on the drawing. Roof truss anchors a spreader braces the trusses and distributes arrest forces across several trusses. Roof truss anchor figure 4 shows a typical roof truss anchor cast into the bond beam of a concrete masonry bearing wall. These roof anchors are easy to install by nailing into the truss and easy to remove by hammering over the attachment point when the job is done.

Fasteners are provided with this product. To install consult the owner s manual and visually determine a location along the bottom truss cord. These anchors do not penetrate the roof sheathing they do not pass go and they do not collect 100. When making a selection below to narrow your results down each selection made will reload the page to display the desired results.

Skew nailing through the connector plate at the heel invariably results in splitting of the timber in the bottom chord. The embedded truss anchor series provides an engineered method to properly attach roof trusses to concrete and masonry walls. Spreaders can act as anchors for personal fall arrest systems and fall restraint. Permanent roof anchors are designed to provide one d ring anchorage point when installed securely on a wood roof sub surface or vertical wall.

Into a poured concrete bond beam or grouted block wall staggered nail pattern for enhanced uplift resistance. If all you have to anchor to is a naked truss these anchors will do the job. They can be reused according to the manufacturer s instructions. In such situation framing anchors or truss clips should be used.

The products are designed with staggered nail patterns for greater uplift resistance. Embedded truss anchors and truss seat snap in an engineered method to attach roof trusses to concrete and masonry walls to resist uplift and lateral loads.